Seals leaks up to max. 0.1 mm
Dirt filters in the cooling circuit are not affected
Can be used as a preventive measure with every antifreeze change
Sealing effect due to microfine, synthetic particles
Can content is sufficient for 10 liters of coolant
The processing information are recommendations based on our tests and experience; Before each application, you must carry out your own tests. Due to the large number of applications and the storage and processing conditions, we do not assume any liability for a specific processing result. Insofar as our free customer service provides technical information or acts in an advisory capacity, this is done with the exclusion of any liability, unless the advice or information is part of our owed, contractually agreed scope of services or the consultant acted intentionally. We guarantee the consistent quality of our products, we reserve the right to make technical changes and further developments.
To be used in the case of micro-leaks in the cylinder head gasket and the hose connections as well as in the case of evaporation losses in cooling system units. For prevention with every antifreeze change. Can also be used with closed cooling systems. Suitable for all conventional antifreeze and coolants
Add directly to the cooling circuit when the engine is warm. Only fill into the expansion tank if coolant is flowing through it. Then let the engine run for at least 10 minutes until the thermostat opens and the heater noticeably emits heat. Then switch off the engine, check the coolant again and top up if necessary